Machinability improvement using high-pressure cooling in turning

R. Drlička, V. Kročko and M. Matúš
Additional contact information
R. Drlička: Department of Quality and Engineering Technologies, Faculty of Engineering, Slovak University of Agriculture in Nitra, Nitra, Slovak Republic
V. Kročko: Department of Quality and Engineering Technologies, Faculty of Engineering, Slovak University of Agriculture in Nitra, Nitra, Slovak Republic
M. Matúš: Department of Quality and Engineering Technologies, Faculty of Engineering, Slovak University of Agriculture in Nitra, Nitra, Slovak Republic

Research in Agricultural Engineering, 2014, vol. 60, issue SpecialIssue, S70-S76

Abstract: Process fluids are used primarily for their cooling and lubricating effect in machining. Many ways to improve their performance have been proposed; the analysis of some of them is provided in the paper. The effect of high pressure cooling has been investigated with regard to chip formation and tool life. Standard and for high pressure application particularly designed indexable cutting inserts were used with fluid pressure 1.5 and 7.5 MPa. The pressure effect on tool life at different feed rates was observed as well. Not each cooling pressure value or machined material showed favourable chip formation. Tool life though has improved significantly while machining with a lower feed rate.

Keywords: tool; indexable insert; high pressure cutting fluid application; cutting parameters; tool life (search for similar items in EconPapers)
Date: 2014
References: View complete reference list from CitEc
Citations:

Downloads: (external link)
http://rae.agriculturejournals.cz/doi/10.17221/38/2013-RAE.html (text/html)
http://rae.agriculturejournals.cz/doi/10.17221/38/2013-RAE.pdf (application/pdf)
free of charge

Related works:
This item may be available elsewhere in EconPapers: Search for items with the same title.

Export reference: BibTeX RIS (EndNote, ProCite, RefMan) HTML/Text

Persistent link: https://EconPapers.repec.org/RePEc:caa:jnlrae:v:60:y:2014:i:specialissue:id:38-2013-rae

DOI: 10.17221/38/2013-RAE

Access Statistics for this article

Research in Agricultural Engineering is currently edited by Bc. Michaela Polcarová

More articles in Research in Agricultural Engineering from Czech Academy of Agricultural Sciences
Bibliographic data for series maintained by Ivo Andrle ().