In vitro heat transfer from epoxy polymer and poly(methyl methacrylate) to fixation pins: recommendations to avoid tissue damage in free-form external skeletal fixation

N. Butto, C. Hamilton-West and J.I. Arias
Additional contact information
N. Butto: Faculty of Veterinary and Animal Science, University of Chile, Santiago de Chile, Chile
C. Hamilton-West: Faculty of Veterinary and Animal Science, University of Chile, Santiago de Chile, Chile

Veterinární medicína, 2018, vol. 63, issue 5, 240-247

Abstract: External skeletal fixation has been used for the management of fractures of many types of bone. The use of polymeric free-form connecting bars in external fixators has become widely used in veterinary orthopaedics because of its versatile forms of frame construction and its relative low costs. Determining thermal-transfer to trans fixation pins during polymerisation of poly(methyl methacrylate) and epoxy putty polymers used for free-form external skeletal fixation connecting bars is important for avoiding temperatures of more than 47 °C, which would cause thermal soft tissue injury. Therefore, thermal transfer to trans fixation pins was measured in vitro during the polymerisation phase of these polymers. We used trocar-pointed pins of different diameters that punctured one wall of a connecting tube, resulting in the tip of the trocar-pointed pin reaching the centre of the tube. The FLUKE® VT02 infrared digital camera was then used to measure heat transfer to the pins at 1 or 2 cm from poly(methyl methacrylate) or epoxy putty. The polymerisation temperatures of these polymers yield a potentially dangerous level of heat for soft and hard tissue. This was observed in almost all the experimental conditions tested. On the other hand, epoxy putty transfer to the pins did not cause the temperature to reach 47 °C at any time or in any of the setups examined. Poly(methyl methacrylate) did reach more than 47 °C and remained at that level for more than 1 min at 1 cm from the polymer. This acrylate exhibited polymerisation temperatures higher than epoxy and its heat transfer to the pins was potentially dangerous if used at less than 1 cm from soft or hard tissue.

Keywords: epoxy putty; bone necrosis; exothermic polymerisation; infrared digital image (search for similar items in EconPapers)
Date: 2018
References: View references in EconPapers View complete reference list from CitEc
Citations:

Downloads: (external link)
http://vetmed.agriculturejournals.cz/doi/10.17221/107/2017-VETMED.html (text/html)
http://vetmed.agriculturejournals.cz/doi/10.17221/107/2017-VETMED.pdf (application/pdf)
free of charge

Related works:
This item may be available elsewhere in EconPapers: Search for items with the same title.

Export reference: BibTeX RIS (EndNote, ProCite, RefMan) HTML/Text

Persistent link: https://EconPapers.repec.org/RePEc:caa:jnlvet:v:63:y:2018:i:5:id:107-2017-vetmed

DOI: 10.17221/107/2017-VETMED

Access Statistics for this article

Veterinární medicína is currently edited by Ing. Helena Smolová Ph.D.

More articles in Veterinární medicína from Czech Academy of Agricultural Sciences
Bibliographic data for series maintained by Ivo Andrle ().