Numerical Simulation Study of Blast Furnace Mixed Blown Pulverized Coal and Hydrochar

Xiaojun Ning, Zheng Ren, Guangze Kan, Haibin Zhang, Junyi Wu and Guangwei Wang ()
Additional contact information
Xiaojun Ning: School of Metallurgical and Ecological Engineering, University of Science and Technology Beijing, Beijing 100083, China
Zheng Ren: School of Metallurgical and Ecological Engineering, University of Science and Technology Beijing, Beijing 100083, China
Guangze Kan: School of Metallurgical and Ecological Engineering, University of Science and Technology Beijing, Beijing 100083, China
Haibin Zhang: Beijing Shougang Corporation Ironmaking Division, Tangshan 064400, China
Junyi Wu: School of Metallurgical and Ecological Engineering, University of Science and Technology Beijing, Beijing 100083, China
Guangwei Wang: School of Metallurgical and Ecological Engineering, University of Science and Technology Beijing, Beijing 100083, China

Sustainability, 2025, vol. 17, issue 18, 1-18

Abstract: In order to alleviate the energy crisis and respond to the “dual carbon strategy”, a new energy substance is needed to replace pulverized coal as the new blast furnace blowing fuel. Hydrochar is a clean and renewable carbon resource with high calorific value, good transportation and storage properties, and low ash content. Numerical simulation is used to study the combustion process of co-blown pulverized coal and hydrochar inside the cyclone zone. In this study, a three-dimensional physical model was constructed based on the actual dimensions of the direct-blowing pipe, tuyere, coal gun, and swirl zone of a large blast furnace in China. Numerical simulation methods were used to study the combustion process of coal powder and hydrothermal carbon co-injected into the swirl zone, and to investigate changes in the swirl zone of the tuyere under different conditions. The results show that increasing the proportion of hydrochar in the blended coal is conducive to improving the combustion rate of the blended coal, the temperature inside the gyratory zone increases significantly with the increase in the oxygen enrichment rate, and the high temperature zone is gradually enlarged. For every 1% increase in the oxygen enrichment rate, the maximum temperature of the centerline of the coal plume increases by 28 K, and the burnout rate increases by 1.12%; the increase in the blast temperature makes the combustion of pulverized coal slightly advance and promotes the increase in the internal temperature of the gyratory zone. The change of the blast temperature to 1559 K is more obvious, and the increase in the blast temperature after it is greater than 1559 K is not significant for the improvement of the burnout rate and the temperature of the gyratory area, and it will increase the cost; the lower the proportion of the small particle size is, the bigger the high temperature area of the gyratory area is, and the higher the temperature of the centerline of the coal strand is. If the content of the volatile matter remains unchanged, the increase in the ratio of the hydrochar has little influence on the temperature field of the gyratory area and the temperature of the centerline of the coal strand. The temperature difference is kept at 20 K. With the increase in the hydrochar ratio, the overall burnout rate of pulverized coal gradually increases. Therefore, hydrochar can replace bituminous coal as blast furnace blowing fuel to a certain extent, which can reduce costs and carbon emissions.

Keywords: hydrochar; numerical simulation; pulverized coal; burn-off rate (search for similar items in EconPapers)
JEL-codes: O13 Q Q0 Q2 Q3 Q5 Q56 (search for similar items in EconPapers)
Date: 2025
References: View references in EconPapers View complete reference list from CitEc
Citations:

Downloads: (external link)
https://www.mdpi.com/2071-1050/17/18/8122/pdf (application/pdf)
https://www.mdpi.com/2071-1050/17/18/8122/ (text/html)

Related works:
This item may be available elsewhere in EconPapers: Search for items with the same title.

Export reference: BibTeX RIS (EndNote, ProCite, RefMan) HTML/Text

Persistent link: https://EconPapers.repec.org/RePEc:gam:jsusta:v:17:y:2025:i:18:p:8122-:d:1745824

Access Statistics for this article

Sustainability is currently edited by Ms. Alexandra Wu

More articles in Sustainability from MDPI
Bibliographic data for series maintained by MDPI Indexing Manager ().