Investigation of Wet-Process Asphalt Rubber Binder Testing with Modified Dynamic Shear Rheometer: Interim Report on Screening Tests

S. S. Hung, F. Farshidi, D. Jones, M. Z. Alavi, J. T. Harvey and H. Sadraie

Institute of Transportation Studies, Working Paper Series from Institute of Transportation Studies, UC Davis

Abstract: In the United States, the Superpave Asphalt Binder Performance Grading (PG) system proposed by the Strategic Highway Research Program (SHRP) is the most common method used to characterize the performance-related properties of conventional and polymer-modified asphalt binders. Dynamic modulus (G*) and phase angle (δ) are the two main binder properties and they are measured using a dynamic shear rheometer (DSR) with parallel plate geometry and either a 1 mm or 2 mm gap between the plates. Since these Superpave parameters were developed for binders that do not contain additives or particulates, the California Department of Transportation (Caltrans) does not use them as asphalt rubber binder specification criteria. Instead, penetration and viscosity are used as acceptance of quality control; however, these parameters do not necessarily provide a satisfactory link between the measured binder properties and potential performance in the field over a range of operating temperatures. In California, current specifications require that crumb rubber particles used to produce asphalt rubber binder in the “wet process” must be smaller than 2.36 mm (i.e., 100 percent passing the #8 sieve), and typically these particles vary in size between 1 mm and 2 mm. As a consequence, when the parallel plate geometry is used to test this type of binder, the larger rubber particles can contact the plates; if this occurs, the rubber particle rheology can potentially dominate the results, which in turn may not be representative of the modified binder as a whole. To address this problem, a potentially more appropriate DSR testing protocol using concentric cylinder geometry was investigated in this study to explore an alternative means of determining the performance properties of asphalt rubber binders. In the first phase of the study, documented in this technical memorandum, a series of tests were undertaken to compare the two geometries and to assess which binder properties influence the results from the testing approaches. The interim results indicate that there is no significant difference between the concentric cylinder and parallel plate geometries in terms of the G*/sinδ after testing on a range of different binders and asphalt rubber binders with finer crumb rubber particle sizes (i.e.

Keywords: Engineering (search for similar items in EconPapers)
Date: 2014-08-01
References: View complete reference list from CitEc
Citations:

Downloads: (external link)
https://www.escholarship.org/uc/item/56w8m91k.pdf;origin=repeccitec (application/pdf)

Related works:
This item may be available elsewhere in EconPapers: Search for items with the same title.

Export reference: BibTeX RIS (EndNote, ProCite, RefMan) HTML/Text

Persistent link: https://EconPapers.repec.org/RePEc:cdl:itsdav:qt56w8m91k

Access Statistics for this paper

More papers in Institute of Transportation Studies, Working Paper Series from Institute of Transportation Studies, UC Davis Contact information at EDIRC.
Bibliographic data for series maintained by Lisa Schiff ().