Improving gas/particle flow deflection and asymmetric combustion of a 600 MWe supercritical down-fired boiler by increasing its upper furnace height

Min Kuang, Qunyi Zhu, Zhongqian Ling, Shuguang Ti and Zhengqi Li

Energy, 2017, vol. 127, issue C, 581-593

Abstract: A solution characterized by lengthening its short upper furnace was put forward for improving the gas/particle flow deflection and asymmetric combustion within a 600 MWe supercritical down-fired boiler. Based on the present design dimensionless upper furnace height CH2 = 0.864, upper furnace was lengthened in turn to CH2 = 1.00, 1.125, and 1.263 so as to form four comparable settings. Accordingly, cold-modeling gas/particle flow experiments and numerical simulations on coal combustion were performed at these settings for confirming the solution and meanwhile recommending a reasonable CH2 setup. Moreover, real-furnace measurements, used to confirm the numerical simulation validity, were carried out under normal full load. Results at the design setting (CH2 = 0.864) show shat a severely deflected gas/particle flow field appears, with (i) the downward gas/particle flow penetrating much deeper in the front-half side than in the rear-half side and (ii) the upward flow fully deflecting towards the front-half side. Consequently, a bad asymmetric combustion pattern with gas temperatures being much higher in the rear-half side than in the front-half side (temperature gap reaching about 300–600 °C) develops, generating poor burnout and high NOx emissions. Additionally, the simulated results are consistent well with the acquired real-furnace data. In comparison with cold-modeling gas/particle flow experiments, the simulated downward gas/particle flow penetrates clearly shallower in a hot environment. Lengthening upper furnace apparently weakens both the experimental and simulated flow-field deflection and meanwhile improves the asymmetric gas velocity distribution in the upper furnace. As CH2 increases to 1.125 and 1.263, both the experimental and simulated flow-field symmetries are acceptable, accompanied by symmetrical gas velocity distribution in the upper furnace, improved burnout rate, and lowered NOx emissions. A comprehensive consideration of symmetrical combustion, high burnout rate, relatively low NOx emissions, and controlled cost for lengthening upper furnace suggests that a reasonable CH2 should be set at 1.125.

Keywords: Down-fired boiler; Flow-field deflection; Asymmetric combustion; Upper furnace height (search for similar items in EconPapers)
Date: 2017
References: View references in EconPapers View complete reference list from CitEc
Citations: View citations in EconPapers (1)

Downloads: (external link)
http://www.sciencedirect.com/science/article/pii/S0360544217305649
Full text for ScienceDirect subscribers only

Related works:
This item may be available elsewhere in EconPapers: Search for items with the same title.

Export reference: BibTeX RIS (EndNote, ProCite, RefMan) HTML/Text

Persistent link: https://EconPapers.repec.org/RePEc:eee:energy:v:127:y:2017:i:c:p:581-593

DOI: 10.1016/j.energy.2017.04.002

Access Statistics for this article

Energy is currently edited by Henrik Lund and Mark J. Kaiser

More articles in Energy from Elsevier
Bibliographic data for series maintained by Catherine Liu ().