Temperature and thermal annealing effects on different photovoltaic technologies

George Makrides, Bastian Zinsser, Alexander Phinikarides, Markus Schubert and George E. Georghiou

Renewable Energy, 2012, vol. 43, issue C, 407-417

Abstract: The effect of temperature on different grid-connected photovoltaic (PV) technologies installed in Cyprus was analyzed in this study. Initially, the performance losses due to the temperature effect on the annual energy yield of each technology were investigated using measurements of module temperature and the manufacturer provided maximum power point (MPP) temperature coefficients, γPMPP. The same methodology was also applied using outdoor evaluated γPMPP coefficients for comparison. When using the manufacturer’s temperature coefficient, the results showed that over the evaluation period the highest average thermal losses in annual dc energy yield were 8% for mono-crystalline silicon (mono-c-Si) and 9% for multi-crystalline silicon (multi-c-Si) technologies while for thin-film technologies, the average losses were 5%. Similar losses were found when using the outdoor evaluated temperature coefficients. Additionally, temperature effects on the seasonal performance of the different technologies were evident on the monthly average performance ratio (PR). For the amorphous silicon (a-Si) technologies, a performance increase from spring until early autumn was observed and was attributed to thermal annealing. The effect of thermal annealing on the performance was evident by filtering dc MPP power measurements at high irradiance (greater than 800 W/m2) and restricting the values at geometric air mass (AM) in the range 1 ≤ geometric AM ≤ 1.5. The extracted dc MPP power was corrected for irradiance and temperature at standard test conditions (STC) using the manufacturer provided γPMPP over a period of two years. Subsequently, the effect of thermal annealing was further investigated by extracting dc MPP power measurements at geometric AM in the range 1.4 ≤ geometric AM ≤ 1.6 in order to minimize the spectral influences on the performance of a-Si technologies. An increase in power for all the a-Si technologies was obvious during the warm summer season and was recorded over the period of March until September for both years.

Keywords: Amorphous silicon; Photovoltaic system; Temperature; Thermal annealing; Thermal losses (search for similar items in EconPapers)
Date: 2012
References: View references in EconPapers View complete reference list from CitEc
Citations: View citations in EconPapers (30)

Downloads: (external link)
http://www.sciencedirect.com/science/article/pii/S0960148111006483
Full text for ScienceDirect subscribers only

Related works:
This item may be available elsewhere in EconPapers: Search for items with the same title.

Export reference: BibTeX RIS (EndNote, ProCite, RefMan) HTML/Text

Persistent link: https://EconPapers.repec.org/RePEc:eee:renene:v:43:y:2012:i:c:p:407-417

DOI: 10.1016/j.renene.2011.11.046

Access Statistics for this article

Renewable Energy is currently edited by Soteris A. Kalogirou and Paul Christodoulides

More articles in Renewable Energy from Elsevier
Bibliographic data for series maintained by Catherine Liu ().