Research in Agricultural Engineering

2003 - 2025

Current editor(s): Bc. Michaela Polcarová

From Czech Academy of Agricultural Sciences
Bibliographic data for series maintained by Ivo Andrle ().

Access Statistics for this journal.
Is something missing from the series or not right? See the RePEc data check for the archive and series.

Volume 63, issue SpecialIssue, 2017

Review of energy potential of the wood biomass of orchards and vineyards in the Czech Republic pp. S1-S7

Patrik Burg, Vladimír Mašán, Martin Dušek, Pavel Zemánek and Kazimierz Rutkowski

Effect of chopped maize straw on the quantity and quality of biogas produced pp. S8-S12

Tomasz K. Dobek, Petr Šařec, Paweł Kołosowski and Ondřej Šařec

Low-cost infrared sensor for wildlife detection in vegetation pp. S13-S17

Jakub Lev, Vadym Shapoval, Jan Bartoška and František Kumhála

Dielectric properties of hops - an effect of bulk density pp. S18-S23

Jakub Lev and František Kumhála

Parameters of the drying medium and dried hops in belt dryer pp. S24-S32

Adolf Rybka, Petr Heřmánek, Ivo Honzík and Karel Krofta

Comparison of logistic, energy and exploitative parameters of compost and manure application by spreaders pp. S33-S39

Jiří Souček, Radek Pražan, Amitava Roy, Petr Plíva, Antonín Jelínek and Jiří Vegricht

Changes in soil properties due to the application of activators in conditions of very heavy soils pp. S40-S45

Petr Šařec and Petr Novák

Translocation of the upper soil layer in multiple operations of seedbed preparation pp. S46-S52

Petr Novák and Josef Hůla

Experimental determination of poplar (Populus nigra L.) wood drying curves pp. S53-S58

Jiří Souček and Milan Kroulík

Technological and economic evaluation of manure production using an activator of biological transformation pp. S59-S65

Petr Šařec, Oldřich Látal and Petr Novák

Automatic guidance systems in agricultural machinery as a tool for drivers' mental strain and workload relief pp. S66-S72

Zděnek Kvíz and Milan Kroulík

Volume 63, issue 4, 2017

Temperature effect on various biooils physical parameters pp. 145-151

Monika Božiková, Petr Hlaváč, Ľubomír Híreš, Zuzana Hlaváčová, Michal Valach, Vlasta Vozárová and Martin Malínek

Estimation of the power consumed in disc crushers using a static analysis pp. 152-159

Antonio Cordova, Juan Manuel Zuñiga, Jose Luis Mantari and Helard Henry Alvarez

The effect of tine, wing, operating depth and speed on the draft requirement of subsoil tillage tines pp. 160-167

Mohammad Askari, Gholamhossein Shahgholi and Yousef Abbaspour-Gilandeh

Investigation of solar-powered drip irrigation: The case study of the Jordan Valley pp. 168-171

Christoforos Perakis, George Kyriakarakos, Nabeel Bani Hani, Shaker Hammad and Markos Damasiotis

Optimal laser marking of 2D data matrix codes on Cavendish bananas pp. 172-179

Indera Sakti Nasution and Thomas Rath

Extremely low frequency electromagnetic field generator suitable for plant in vitro studies pp. 180-186

Riry Prihatini, Mohamad Puad Abdullah, Tuan Abdul Rashid bin Tuan Abdullah, Ismail Said, Halil Hussin and Norihan Mohamad Saleh

INDEX OF VOLUME 63 (2017) pp. X1

Editors

Volume 63, issue 3, 2017

Risk analysis of the business profitability in agricultural companies using combine harvesters pp. 99-105

Miroslav Mimra, Miroslav Kavka and František Kumhála

Research on wear resistance of poly-component composite materials pp. 106-114

Miroslav Müller and Jiří Kejval

Evaluation of properties of elastomer seal for fuel systems exposed to effects of rapeseed methyl ester pp. 115-120

Vladimír Šleger, Miroslav Müller and Martin Pexa

Kinetics on anaerobic co-digestion of bagasse and digested cow manure with short hydraulic retention time pp. 121-127

Darwin, Afrizal Fazil, Muhammad Ilham, Sarbaini and Satria Purwanto

A novel method for the quantification of interfacial tomato stresses during transportation pp. 128-135

Wynand Jacobus van der Merwe Steyn

Non-stationary processing centre for small and mediumsized blueberry farms. A Review pp. 136-144

Kaarel Soots and Jüri Olt

Volume 63, issue 2, 2017

The use of stereophotogrammetry to determine the size and spatial coordinates to generate a 3D model of an animal pp. 47-53

Ladislav Libich, Michal Hruška, Petr Vaculík and Miroslav Přikryl

Evaluation of efficiency of technologies for wastewater sludge hygienisation pp. 54-61

Petr Junga, Pavel Mach and Jan Mareček

Manure leachate production and change in manure weight during the storage depending on the amount of bedding pp. 62-70

Jiří Vegricht, Josef Šimon and Jiří Bradna

Moisture content modelling of thermal properties of persimmon (cv. 'Kaki') pp. 71-78

Somaye Akbari and Reza Amiri Chayjan

Thermal properties of soursop seeds and kernels pp. 79-85

Christopher Tunji Oloyede, Fatai Bukola Akande, Kazeem Olaniyi Oriola and Oluwole Oluwatoyin Oniya

Content of microorganisms in cereal straw pp. 86-90

Jiří Souček

Abrasive wear resistance of selected woods pp. 91-97

Milan Brožek

Volume 63, issue 1, 2017

Evaluation of new biodegradable fluid on the basis of accelerated durability test, FTIR and ICP spectroscopy pp. 1-9

Juraj Tulík, Ľubomir Hujo, Jan Kosiba, Juraj Jablonický and Michela Jánošová

Temperature changes of I-V characteristics of photovoltaic cells as a consequence of the Fermi energy level shift pp. 10-15

Martin Libra, Vladislav Poulek and Pavel Kouřím

Heating and emission properties of waste biomass in burner furnace pp. 16-22

Jan Malaťák and Jiří Bradna

Effect of moisture and region of cut on cassava stalk properties in biomass applications pp. 23-28

Nisanath Kaewwinud, Porntep Khokhajaikiat and Apichart Boonma

Investigation of locust bean husk char adsorbability in heavy metal removal pp. 29-35

Ademola Ajayi-Banji, Ayo Ogunlela and Gbolabo Ogunwande

Analysis of production parameters of single-lap bonds adhesive bonded with composites based on aluminium filler pp. 36-44

Miroslav Müller

Volume 62, issue SpecialIssue, 2016

The effect of granulometric structure and moisture of fertilizer on its static strength pp. S1-S7

M Macák and K Krištof

Thermodynamics of combustion gases from biogas pp. S8-S13

I. Vitázek, J. Klúčik, D. Uhrinová, Z. Mikulová and M. Mojžiš

Ideal cycle of combustion engine with natural gas as a fuel pp. S14-S20

I. Vitázek, J. Klúčik, J. Jablonický and P. Vereš

Impact of shelter on daylight in the stables for dairy cows pp. S21-S26

M. Balková and R. Záhorská

The device of magnetic processing of water for boiler greenhouse pp. S27-S33

S.N. Antonov, S.Z. Gabriyelyan, M.A. Mastepanenko, E.B. Zorina and L. Nozdrovický

The effectiveness of heating of housing unit by renewable energy source pp. S34-S43

J. Jobbágy, K. Krištof and M. Andacký

Testing of property changes in recycled bedding for dairy cows pp. S44-S52

J. Lendelová, M. Žitňák, M. Bošanský, M. Šimko and P. Piterka

Hazard analysis in operating of the post-harvest lines pp. S53-S60

M. Prístavková, M. Žitňák and J. Lendelová

Biomass combustion emissions pp. S61-S65

V. Kažimírová and R. Opáth

Monitoring of selected emissions of internal combustion engine pp. S66-S70

M. Králik, J. Jablonický, Z. Tkáč, Ľ. Hujo, D. Uhrinová, J. Kosiba, J. Tulik and R. Záhorská

Volume 62, issue 4, 2016

Yield and fuel characteristics of willows tested for biomass production on agricultural soil pp. 155-161

J. Weger, P. Hutla and J. Bubeník

Effect of moisture content on some physical properties of Canarium schweinfurthii Engl. fruits pp. 162-169

J.C. Ehiem, V.I.O. Ndirika and U.N. Onwuka

Drying characteristics of eggplant (Solanum melongena L.) slices under microwave-convective drying pp. 170-178

R.A. Chayjan and M. Kaveh

Mass yield of biochar from hydrothermal carbonization of sucrose pp. 179-184

J. Velebil, J. Malaťák and J. Bradna

Frequency analysis of noise exposure of dairy cows in the process of milking pp. 185-189

M. Pšenka, M. Šístková, Š. Mihina and R. Gálik

Some causes of differences in the NH3 concentration measured with the semiconductor sensors by one manufacturer pp. 190-197

P. Zabloudilová, J. Pecen and M. Češpiva

Bonding of plywood pp. 198-204

M. Brožek

INDEX OF VOLUME 62 pp. X1

Editors

Volume 62, issue 3, 2016

Mechanical properties of composite material reinforced with textile waste from the process of tyres recycling pp. 99-105

M. Müller

The experimental research of combine harvesters pp. 106-112

L. Špokas, V. Adamčuk, V. Bulgakov and L. Nozdrovický

Sensitivity analysis of key operating parameters of combine harvesters pp. 113-121

M. Kavka, M. Mimra and F. Kumhála

Emission load of car service interiors pp. 122-128

I. Vitázek, D. Michalíková, B. Vitázková and J. Klúčik

Moisture and thermal diffusivity of lentil seed under convective infrared-microwave: Modelling with and without shrinkage pp. 129-140

R.A. Chayjan and S.A. Radmard

Rating of malt grist fineness with respect to the used grinding equipment pp. 141-146

A. Smejtková, P. Vaculík, M. Přikryl and Z. Pastorek

Changes in selected wine physical properties during the short-time storage pp. 147-153

P. Hlaváč, M. Božiková, Z. Hlaváčová and K. Kardjilova

Volume 62, issue 2, 2016

Application of 3D cameras in agriculture when evaluating the quality of soil tillage pp. 39-49

M. Kříž, M. Linda, J. Svatoš and M. Hromasová

Using of tiny encryption algorithm in CAN-Bus communication pp. 50-55

M. Jukl and J. Čupera

Pneumatic conveying characteristics of seeds in a vertical ascending airstream pp. 56-63

M. Kroulík, J. Hůla, A. Rybka and I. Honzík

Hydrothermal carbonization of kitchen waste pp. 64-72

J. Malaťák and T. Dlabaja

Studies on biogas production by anaerobic process using agroindustrial wastes pp. 73-82

P. Elaiyaraju and N. Partha

Influence of weather conditions on waste biomass production pp. 83-91

O. Chotovinský and V. Altmann

Evaluation of Miscanthus grown for energy use pp. 92-97

Z Strašil

Volume 62, issue 1, 2016

Flue gases thermal emission concentration during waste biomass combustion in small combustion device with manual fuel supply pp. 1-8

J. Bradna and J. Malaťák

Effect of inoculum to substrate ratio on biogas production of sheep paunch manure pp. 8-14

A.A. Lawal, A.U. Dzivama and M.K. Wasinda

Effective moisture diffusivity during hot air solar drying of tomato slices pp. 15-23

H. Samimi. Akhijani, A. Arabhosseini and M.H. Kianmehr

Monitoring of operation loading of three-point linkage during ploughing pp. 24-29

Ľ. Hujo, Z. Tkáč, J. Tulík, J. Kosiba, D. Uhrinová and M. Jánošová

Methodology of processing the results of field experiment monitoring of the technological procedure of sowing pp. 30-36

V. Bulgakov, V. Melnik, A.F.M.A. Mohammed, M. Korenko and K. Kollárová