Energy
1976 - 2025
Current editor(s): Henrik Lund and Mark J. Kaiser From Elsevier Bibliographic data for series maintained by Catherine Liu (). Access Statistics for this journal.
Is something missing from the series or not right? See the RePEc data check for the archive and series.
Volume 50, issue C, 2013
- Evaluation of the wind and wave energy along the Caspian Sea pp. 1-14

- Eugen Rusu and Florin Onea
- Life-cycle fossil energy consumption and greenhouse gas emission intensity of dominant secondary energy pathways of China in 2010 pp. 15-23

- Xin Li, Xunmin Ou, Xu Zhang, Qian Zhang and Xiliang Zhang
- Daily hydrothermal scheduling with economic emission using simulated annealing technique based multi-objective cultural differential evolution approach pp. 24-37

- Huifeng Zhang, Jianzhong Zhou, Na Fang, Rui Zhang and Yongchuan Zhang
- The thermodynamics of direct air capture of carbon dioxide pp. 38-46

- Klaus S. Lackner
- Reducing tar yield in gasification of paper-reject sludge by using a hot-gas cleaning system pp. 47-53

- Kung-Yuh Chiang, Cheng-Han Lu, Ming-Hui Lin and Kuang-Li Chien
- Energy inputs and greenhouse gases emissions in wheat production in Gorgan, Iran pp. 54-61

- Afshin Soltani, M.H. Rajabi, E. Zeinali and Elias Soltani
- The impact of copper scarcity on the efficiency of 2050 global renewable energy scenarios pp. 62-73

- J.H.M. Harmsen, A.L. Roes and M.K. Patel
- Risk based multiobjective generation expansion planning considering renewable energy sources pp. 74-82

- Mohsen Gitizadeh, Mahdi Kaji and Jamshid Aghaei
- Techno-economic analysis of a kraft pulp-mill-based biorefinery producing both ethanol and dimethyl ether pp. 83-92

- Rickard Fornell, Thore Berntsson and Anders Åsblad
- The potential of wind energy to largely displace existing Canadian fossil fuel and nuclear electricity generation pp. 93-102

- L.D. Danny Harvey
- Energy saving methods for the separation of a minimum boiling point azeotrope using an intermediate entrainer pp. 103-109

- G. Modla
- A physically-based model for simulating inverter type air conditioners/heat pumps pp. 110-119

- A. Gomes, C. Henggeler Antunes and J. Martinho
- Evaluation of time series techniques to characterise domestic electricity demand pp. 120-130

- Fintan McLoughlin, Aidan Duffy and Michael Conlon
- Application of porous medium burner with micro cogeneration system pp. 131-142

- Ahmad Kamal Ismail, Mohd Zulkifly Abdullah, Mohammed Zubair, Zainal Arifin Ahmad, Abdul Rashid Jamaludin, Khairil Faizi Mustafa and Mohamad Nazir Abdullah
- Optimum slip flow based on the minimization of entropy generation in parallel plate microchannels pp. 143-149

- Guillermo Ibáñez, Aracely López, Joel Pantoja, Joel Moreira and Juan A. Reyes
- Study of knock in a high compression ratio spark-ignition methanol engine by multi-dimensional simulation pp. 150-159

- Xudong Zhen, Yang Wang, Shuaiqing Xu and Yongsheng Zhu
- Combustion vs. gasification for a demonstration CCS (carbon capture and storage) project in Italy: A techno-economic analysis pp. 160-169

- Alberto Pettinau, Francesca Ferrara and Carlo Amorino
- Optimization and testing on an adsorption dishwasher pp. 170-176

- G. Santori, A. Frazzica, A. Freni, M. Galieni, L. Bonaccorsi, F. Polonara and G. Restuccia
- Prediction of engine performance and exhaust emissions for gasoline and methanol using artificial neural network pp. 177-186

- Yusuf Çay, Ibrahim Korkmaz, Adem Çiçek and Fuat Kara
- The cold start performance of a spark-ignited dimethyl ether engine pp. 187-193

- Changwei Ji, Chen Liang, Binbin Gao, Baojian Wei, Xiaolong Liu and Yongming Zhu
- Dynamic characteristics of a direct-heated supercritical carbon-dioxide Brayton cycle in a solar thermal power plant pp. 194-204

- Rajinesh Singh, Sarah A. Miller, Andrew S. Rowlands and Peter A. Jacobs
- No-load loss calculation of distribution transformers supplied by nonsinusoidal voltage using three-dimensional finite element analysis pp. 205-219

- Mohammad Yazdani-Asrami, Mohammad Mirzaie and Amir Abbas Shayegani Akmal
- Water transport through a PEM (proton exchange membrane) fuel cell in a seven-layer model pp. 220-231

- S. Rakhshanpouri and S. Rowshanzamir
- An efficient scenario-based and fuzzy self-adaptive learning particle swarm optimization approach for dynamic economic emission dispatch considering load and wind power uncertainties pp. 232-244

- Bahman Bahmani-Firouzi, Ebrahim Farjah and Rasoul Azizipanah-Abarghooee
- Modelling HGV freight transport energy demand in Ireland and the impacts of the property construction bubble pp. 245-251

- Kieran Whyte, Hannah E. Daly and Brian P. Ó Gallachóir
- Simulation of hybrid renewable microgeneration systems in load sharing applications pp. 252-261

- E. Entchev, L. Yang, M. Ghorab and E.J. Lee
- Operating strategy for exhaust gas reduction and performance improvement in a heavy-duty hydrogen-natural gas blend engine pp. 262-269

- Cheolwoong Park, Changgi Kim, Young Choi and Janghee Lee
- Development of intelligent MPPT (maximum power point tracking) control for a grid-connected hybrid power generation system pp. 270-279

- Chih-Ming Hong, Ting-Chia Ou and Kai-Hung Lu
- The effect of natural gas composition on the regulated emissions, gaseous toxic pollutants, and ultrafine particle number emissions from a refuse hauler vehicle pp. 280-291

- Georgios Karavalakis, Maryam Hajbabaei, Thomas D. Durbin, Kent C. Johnson, Zhongqing Zheng and Wayne J. Miller
- Causality issue in the heat balance method for calculating the design heating and cooling load pp. 292-301

- Christian Ghiaus
- A study of carbon dioxide emissions performance of China's transport sector pp. 302-314

- Guanghui Zhou, William Chung and Xiliang Zhang
- A bottom-up model to estimate the energy efficiency improvement and CO2 emission reduction potentials in the Chinese iron and steel industry pp. 315-325

- Ali Hasanbeigi, William Morrow, Jayant Sathaye, Eric Masanet and Tengfang Xu
- Power consumption for stirring shear thinning fluids by two-blade impeller pp. 326-332

- Houari Ameur and Mohamed Bouzit
- Characterisation of tars from biomass gasification: Effect of the operating conditions pp. 333-342

- J.J. Hernández, R. Ballesteros and G. Aranda
- Efficiency and optimal performance evaluation of organic Rankine cycle for low grade waste heat power generation pp. 343-352

- Dongxiang Wang, Xiang Ling, Hao Peng, Lin Liu and LanLan Tao
- Exploration of the integration of renewable resources into California's electric system using the Holistic Grid Resource Integration and Deployment (HiGRID) tool pp. 353-363

- Joshua D. Eichman, Fabian Mueller, Brian Tarroja, Lori Smith Schell and Scott Samuelsen
- Pre-combustion capture of carbon dioxide in a fixed bed reactor using the clathrate hydrate process pp. 364-373

- Ponnivalavan Babu, Rajnish Kumar and Praveen Linga
- Automated superstructure-based synthesis and optimization of distributed energy supply systems pp. 374-388

- Philip Voll, Carsten Klaffke, Maike Hennen and André Bardow
- Effect of the working fluid on the optimum work of binary-flashing geothermal power plants pp. 389-394

- Baktosh H. Edrisi and Efstathios E. Michaelides
- Evaluation of wind energy potentiality at coastal locations along the north eastern coasts of Turkey pp. 395-405

- Adem Akpınar
- Characteristics of a direct methanol fuel cell system with the time shared fuel supplying approach pp. 406-411

- Youngseung Na, Jungmin Kwon, Hyun Kim, Hyejung Cho and Inseob Song
- Modeling and optimization of a binary geothermal power plant pp. 412-428

- Hadi Ghasemi, Marco Paci, Alessio Tizzanini and Alexander Mitsos
- On-farm storage of baled and pelletized canola (Brassica napus L.) straw: Variations in the combustion related properties pp. 429-437

- Leticia Chico-Santamarta, Richard John Godwin, Keith Chaney, David Richard White and Andrea Claire Humphries
- Influence of an aluminium additive in aqueous and solid speciation of elements in flue gas desulphurisation (FGD) system pp. 438-444

- Patricia Córdoba, Carlos Ayora, Natalia Moreno, Oriol Font, Maria Izquierdo and Xavier Querol
- Optimal chiller loading in a district cooling system with thermal energy storage pp. 445-453

- Kody M. Powell, Wesley J. Cole, Udememfon F. Ekarika and Thomas F. Edgar
- Performance analysis of an integrated energy storage and energy upgrade thermochemical solid–gas sorption system for seasonal storage of solar thermal energy pp. 454-467

- Tingxian Li, Ruzhu Wang, Jeremiah K. Kiplagat and YongTae Kang
- Thermal characteristic prediction models for a free-form building in various climate zones pp. 468-476

- Jeong-Tak Jin and Jae-Weon Jeong
- Environmental and thermodynamic evaluation of CO2 capture, transport and storage with and without enhanced resource recovery pp. 477-485

- Diego Iribarren, Fontina Petrakopoulou and Javier Dufour
- Electrocatalytic approach for the efficiency increase of electrolytic hydrogen production: Proof-of-concept using platinum--dysprosium alloys pp. 486-492

- D.M.F. Santos, B. Šljukić, C.A.C. Sequeira, D. Macciò, A. Saccone and J.L. Figueiredo
- Heat transfer to the riser-wall of a circulating fluidised bed (CFB) pp. 493-500

- A. Brems, G. Cáceres, R. Dewil, J. Baeyens and F. Pitié
- Heuristic indicators for the design of community off-grid electrification systems based on multiple renewable energies pp. 501-512

- Matteo Ranaboldo, Laia Ferrer-Martí, Alberto García-Villoria and Rafael Pastor Moreno
- Thermodynamic analysis and optimization of an ammonia-water power system with LNG (liquefied natural gas) as its heat sink pp. 513-522

- Jiangfeng Wang, Zhequan Yan, Man Wang and Yiping Dai
| |