Applied Energy

1975 - 2025

Current editor(s): J. Yan

From Elsevier
Bibliographic data for series maintained by Catherine Liu ().

Access Statistics for this journal.
Is something missing from the series or not right? See the RePEc data check for the archive and series.

2015, volume 159, articles C

Optical and thermal performance of double receiver compound parabolic concentrator pp. 1-10

B. Abdullahi, R.K. AL-Dadah, S. Mahmoud and R. Hood

A meta-analysis of carbon capture and storage technology assessments: Understanding the driving factors of variability in cost estimates pp. 11-18

Oguz Akbilgic, Ganesh Doluweera, Maryam Mahmoudkhani and Joule Bergerson

Influence of leg sizing and spacing on power generation and thermal stresses of thermoelectric devices pp. 19-27

Ugur Erturun, Kaan Erermis and Karla Mossi

A novel self-heat recuperative dividing wall column to maximize energy efficiency and column throughput in retrofitting and debottlenecking of a side stream column pp. 28-38

Nguyen Van Duc Long, Le Quang Minh, Le Cao Nhien and Moonyong Lee

Correlation of energy storage performance of supercapacitor with iso-propanol improved wettability of aqueous electrolyte on activated carbon electrodes of various apparent densities pp. 39-50

Denys G. Gromadskyi, Jung H. Chae, Stuart A. Norman and George Z. Chen

Analysis of multi-scale chaotic characteristics of wind power based on Hilbert–Huang transform and Hurst analysis pp. 51-61

Zhengtang Liang, Jun Liang, Li Zhang, Chengfu Wang, Zhihao Yun and Xu Zhang

Incorporation of electricity GHG emissions intensity variability into building environmental assessment pp. 62-69

Eduard Cubi, Ganesh Doluweera and Joule Bergerson

Experimental investigation of a two-inlet air-based building integrated photovoltaic/thermal (BIPV/T) system pp. 70-79

Tingting Yang and Andreas K. Athienitis

Design and characterisation of a high powered energy dense zeolite thermal energy storage system for buildings pp. 80-86

Kévyn Johannes, Frédéric Kuznik, Jean-Luc Hubert, Francois Durier and Christian Obrecht

Dieseline fueled flexible fuel compression ignition engine control based on in-cylinder pressure sensor pp. 87-96

Jinli Wang, Fuyuan Yang and Minggao Ouyang

Modelling sustainable urban travel in a whole systems energy model pp. 97-107

Steve Pye and Hannah Daly

Is climate change-centrism an optimal policy making strategy to set national electricity mixes? pp. 108-116

Ian Vázquez-Rowe, Janet L. Reyna, Samy García-Torres and Ramzy Kahhat

High load performance and combustion analysis of a four-valve direct injection gasoline engine running in the two-stroke cycle pp. 117-131

Macklini Dalla Nora and Hua Zhao

Density functional theory study on the reaction between hematite and methane during chemical looping process pp. 132-144

Liang Huang, Mingchen Tang, Maohong Fan and Hansong Cheng

Series–Parallel PV array re-configuration: Maximization of the extraction of energy and much more pp. 145-160

M. Balato, L. Costanzo and M. Vitelli

Modeling and optimization of building mix and energy supply technology for urban districts pp. 161-177

Robert E. Best, Forest Flager and Michael D. Lepech

Photovoltaic diffusion from the bottom-up: Analytical investigation of critical factors pp. 178-187

Kathrin Reinsberger, Thomas Brudermann, Stefanie Hatzl, Eva Fleiß and Alfred Posch

Continuous recycling of enzymes during production of lignocellulosic bioethanol in demonstration scale pp. 188-195

Mai Østergaard Haven, Jane Lindedam, Martin Dan Jeppesen, Michael Elleskov, Ana Cristina Rodrigues, Miguel Gama, Henning Jørgensen and Claus Felby

Why is the reliability of building simulation limited as a tool for evaluating energy conservation measures? pp. 196-205

Nan Li, Zheng Yang, Burcin Becerik-Gerber, Chao Tang and Nanlin Chen

Vapor pressure and corrosivity of ternary metal-chloride molten-salt based heat transfer fluids for use in concentrating solar power systems pp. 206-213

K. Vignarooban, Xinhai Xu, K. Wang, E.E. Molina, P. Li, D. Gervasio and A.M. Kannan

An overview: Energy saving and pollution reduction by using green fuel blends in diesel engines pp. 214-236

John Kennedy Mwangi, Wen-Jhy Lee, Yu-Cheng Chang, Chia-Yang Chen and Lin-Chi Wang

Current status and future choices of regional sectors-energy-related CO2 emissions: The third economic growth pole of China pp. 237-251

Feifei Tan and Zhaohua Lu

Financial and environmental analysis of rooftop photovoltaic installations with battery storage in Australia pp. 252-264

A. Nicholls, R. Sharma and T.K. Saha

Robust optimal design of building cooling systems considering cooling load uncertainty and equipment reliability pp. 265-275

Wenjie Gang, Shengwei Wang, Fu Xiao and Dian-ce Gao

Performance analysis of the micro gas turbine Turbec T100 with a new FLOX-combustion system for low calorific fuels pp. 276-284

T. Zornek, T. Monz and M. Aigner

A novel multistage Support Vector Machine based approach for Li ion battery remaining useful life estimation pp. 285-297

Meru A. Patil, Piyush Tagade, Krishnan S. Hariharan, Subramanya M. Kolake, Taewon Song, Taejung Yeo and Seokgwang Doo

Commercial Building Energy Saver: An energy retrofit analysis toolkit pp. 298-309

Tianzhen Hong, Mary Ann Piette, Yixing Chen, Sang Hoon Lee, Sarah C. Taylor-Lange, Rongpeng Zhang, Kaiyu Sun and Phillip Price

Implementation of a firebed cooling device and its influence on emissions and combustion parameters at a residential wood pellet boiler pp. 310-316

M. Gehrig, S. Pelz, D. Jaeger, G. Hofmeister, A. Groll, H. Thorwarth and W. Haslinger

Effect of internal woven roller shade and glazing on the energy and daylighting performances of an office building in the cold climate of Shillong pp. 317-333

Ramkishore Singh, I.J. Lazarus and V.V.N. Kishore

Impact of wind power uncertainty forecasting on the market integration of wind energy in Spain pp. 334-349

I. González-Aparicio and A. Zucker

Double acting Stirling engine: Modeling, experiments and optimization pp. 350-361

Gwyddyon Féniès, Fabien Formosa, Julien Ramousse and Adrien Badel

Measured overall heat transfer coefficient of a suspended particle device switchable glazing pp. 362-369

Aritra Ghosh, Brian Norton and Aidan Duffy

Pontryagin’s Minimum Principle-based power management of a dual-motor-driven electric bus pp. 370-380

Shuo Zhang, Rui Xiong and Chengning Zhang

Retrofit of heat exchanger networks without topology modifications and additional heat transfer area pp. 381-390

Mary O. Akpomiemie and Robin Smith

Self-balancing robust scheduling with flexible batch loads for energy intensive corporate microgrid pp. 391-400

Kun Liu, Xiaohong Guan, Feng Gao, Qiaozhu Zhai and Jiang Wu

Modelling and optimization of CHP based district heating system with renewable energy production and energy storage pp. 401-421

Haichao Wang, Wusong Yin, Elnaz Abdollahi, Risto Lahdelma and Wenling Jiao

Estimating the value of electricity storage in an energy-only wholesale market pp. 422-432

Dylan McConnell, Tim Forcey and Mike Sandiford

Comparison of real-world fuel economy and emissions from parallel hybrid and conventional diesel buses fitted with selective catalytic reduction systems pp. 433-441

Jiadong Guo, Yunshan Ge, Lijun Hao, Jianwei Tan, Zihang Peng and Chuanzhen Zhang

Effect of shock waves on the evolution of high-pressure fuel jets pp. 442-448

Weidi Huang, Zhijun Wu, Ya Gao and Lin Zhang

Compact development and energy consumption: Scenario analysis of urban structures based on behavior simulation pp. 449-457

Yanhong Yin, Shoshi Mizokami and Kohei Aikawa

Theoretical and experimental investigations of thermoelectric heating system with multiple ventilation channels pp. 458-468

Di Liu, Fu-Yun Zhao, Hongxing Yang and Guang-Fa Tang

Performance investigation of an advanced multi-effect adsorption desalination (MEAD) cycle pp. 469-477

Kyaw Thu, Young-Deuk Kim, Muhammad Wakil Shahzad, Jayaprakash Saththasivam and Kim Choon Ng

Carbon savings in the UK demand side response programmes pp. 478-489

E.T. Lau, Q. Yang, L. Stokes, G.A. Taylor, A.B. Forbes, P. Clarkson, P.S. Wright and V.N. Livina

Building envelope with a new aerogel-based insulating rendering: Experimental and numerical study, cost analysis, and thickness optimization pp. 490-501

Mohamad Ibrahim, Pascal Henry Biwole, Patrick Achard, Etienne Wurtz and Guillaume Ansart

Performance analyses of building energy on phase transition processes of VO2 windows with an improved model pp. 502-508

Jian Yang, Zhengtao Xu, Hong Ye, Xiaojie Xu, Xi Wu and Jianxiang Wang

Optimal control of greenhouse climate using minimal energy and grower defined bounds pp. 509-519

P.J.M. van Beveren, J. Bontsema, G. van Straten and E.J. van Henten

GIS-modelling based coal-fired power plant site identification and selection pp. 520-539

Jiuping Xu, Xiaoling Song, Yimin Wu and Ziqiang Zeng

Geospatial assessment of potential bioenergy crop production on urban marginal land pp. 540-547

Mithun Saha and Matthew J. Eckelman

Understanding the full climate change impact of energy consumption and mitigation at the end-use level: A proposed methodology for allocating indirect carbon dioxide emissions pp. 548-559

Stephane de la Rue du Can, Lynn Price and Timm Zwickel

Thermophotovoltaics: Fundamentals, challenges and prospects pp. 560-575

Hoofar Daneshvar, Rajiv Prinja and Nazir P. Kherani

The optimization of a hybrid energy storage system at subzero temperatures: Energy management strategy design and battery heating requirement analysis pp. 576-588

Ziyou Song, Heath Hofmann, Jianqiu Li, Jun Hou, Xiaowu Zhang and Minggao Ouyang

Explaining domestic energy consumption – The comparative contribution of building factors, socio-demographics, behaviours and attitudes pp. 589-600

Gesche M. Huebner, Ian Hamilton, Zaid Chalabi, David Shipworth and Tadj Oreszczyn

Integration of form-stable paraffin/nanosilica phase change material composites into vacuum insulation panels for thermal energy storage pp. 601-609

Xiangyu Li, Huisu Chen, Huiqiang Li, Lin Liu, Zeyu Lu, Tao Zhang and Wen Hui Duan

Genetic optimization of multi-plant heat production in district heating networks pp. 610-619

Tingting Fang and Risto Lahdelma

Improving the concentration ratio of parabolic troughs using a second-stage flat mirror pp. 620-632

David Rodriguez-Sanchez and Gary Rosengarten

Numerical simulation for the design analysis of kinematic Stirling engines pp. 633-650

Joseph A. Araoz, Marianne Salomon, Lucio Alejo and Torsten H. Fransson